Jump to content

Silver iodide

From Wikipedia, the free encyclopedia
(Redirected from Silver(I) iodide)
Silver iodide
Silver iodide
Names
IUPAC name
Silver(I) iodide
Other names
Argentous iodide
Identifiers
3D model (JSmol)
ChemSpider
ECHA InfoCard 100.029.125 Edit this at Wikidata
EC Number
  • 232-038-0
UNII
  • InChI=1S/Ag.HI/h;1H/q+1;/p-1 checkY
    Key: MSFPLIAKTHOCQP-UHFFFAOYSA-M checkY
  • InChI=1/Ag.HI/h;1H/q+1;/p-1
    Key: MSFPLIAKTHOCQP-REWHXWOFAV
  • [Ag]I
Properties
AgI
Molar mass 234.77 g/mol
Appearance yellow, crystalline solid
Odor odorless
Density 5.68 g/cm3, solid[1]
Melting point 558 °C (1,036 °F; 831 K)[1]
Boiling point 1,506 °C (2,743 °F; 1,779 K)[1]
0.03 mg/L (20 °C)[1]
8.52 × 10 −17[2]
−80.0·10−6 cm3/mol[3]
Structure[5]
Hexagonal, hP4
P63mc, No. 186
a = 0.4591 nm, c = 0.7508 nm
α = 90°, β = 90°, γ = 120°
2
4.55 D[4]
Thermochemistry[6]
56.8 J·mol−1·K−1
115.5 J·mol−1·K−1
−61.8 kJ·mol−1
−66.2 kJ·mol−1
Hazards
GHS labelling:[7]
GHS09: Environmental hazard
Warning
H410
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 2: Intense or continued but not chronic exposure could cause temporary incapacitation or possible residual injury. E.g. chloroformFlammability 0: Will not burn. E.g. waterInstability 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no code
2
0
0
Flash point Non-flammable
Safety data sheet (SDS) Sigma-Aldrich
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)

Silver iodide is an inorganic compound with the formula AgI. The compound is a bright yellow solid, but samples almost always contain impurities of metallic silver that give a grey colouration. The silver contamination arises because some samples of AgI can be highly photosensitive. This property is exploited in silver-based photography. Silver iodide is also used as an antiseptic and in cloud seeding.

Structure

[edit]

The structure adopted by silver iodide is temperature dependent:[8]

  • Below 420 K, the β phase of AgI, with the wurtzite structure, is most stable. This phase is encountered in nature as the mineral iodargyrite.
  • Above 420 K, the α phase becomes more stable. This motif is a body-centered cubic structure which has the silver centers distributed randomly between 6 octahedral, 12 tetrahedral and 24 trigonal sites.[9] At this temperature, Ag+ ions can move rapidly through the solid, allowing fast ion conduction. The transition between the β and α forms represents the melting of the silver (cation) sublattice. The entropy of fusion for α-AgI is approximately half that for sodium chloride (a typical ionic solid). This can be rationalized by considering the AgI crystalline lattice to have already "partly melted" in the transition between α and β polymorphs.
  • A metastable γ phase also exists below 420 K with the zinc blende structure.
The golden-yellow crystals on this mineral sample are iodargyrite, a naturally occurring form of β-AgI.

Preparation and properties

[edit]

Silver iodide is prepared by reaction of an iodide solution (e.g., potassium iodide) with a solution of silver ions (e.g., silver nitrate). A yellowish solid quickly precipitates. The solid is a mixture of the two principal phases. Dissolution of the AgI in hydroiodic acid, followed by dilution with water, precipitates β-AgI. Alternatively, dissolution of AgI in a solution of concentrated silver nitrate followed by dilution affords α-AgI.[10] Unless the preparation is conducted in dark conditions, the solid darkens rapidly, the light causing the reduction of ionic silver to metallic. The photosensitivity varies with sample purity.

Cloud seeding

[edit]
Cessna 210 equipped with a silver iodide generator for cloud seeding

The crystalline structure of β-AgI is similar to that of ice, allowing it to induce freezing by the process known as heterogeneous nucleation. Approximately 50,000 kg are used for cloud seeding annually, each seeding experiment consuming 10–50 grams.[11] (see also Project Stormfury, Operation Popeye).[citation needed]

Safety

[edit]

Extreme exposure can lead to argyria, characterized by localized discolouration of body tissue.[12]

References

[edit]
  1. ^ a b c d Haynes, p. 4.84
  2. ^ Haynes, p. 5.178
  3. ^ Haynes, p. 4.130
  4. ^ Haynes, p. 9.65
  5. ^ Yoshiasa, A.; Koto, K.; Kanamaru, F.; Emura, S.; Horiuchi, H. (1987). "Anharmonic thermal vibrations in wurtzite-type AgI". Acta Crystallographica Section B: Structural Science. 43 (5): 434–440. Bibcode:1987AcCrB..43..434Y. doi:10.1107/S0108768187097532.
  6. ^ Haynes, p. 5.35
  7. ^ "C&L Inventory". echa.europa.eu. Retrieved 15 December 2021.
  8. ^ Binner, J. G. P.; Dimitrakis, G.; Price, D. M.; Reading, M.; Vaidhyanathan, B. (2006). "Hysteresis in the β–α Phase Transition in Silver Iodine" (PDF). Journal of Thermal Analysis and Calorimetry. 84 (2): 409–412. CiteSeerX 10.1.1.368.2816. doi:10.1007/s10973-005-7154-1. S2CID 14573346.
  9. ^ Hull, Stephen (2007). "Superionics: crystal structures and conduction processes". Rep. Prog. Phys. 67 (7): 1233–1314. doi:10.1088/0034-4885/67/7/R05. S2CID 250874771.
  10. ^ O. Glemser, H. Saur "Silver Iodide" in Handbook of Preparative Inorganic Chemistry, 2nd Ed. Edited by G. Brauer, Academic Press, 1963, NY. Vol. 1. p. 1036-7.
  11. ^ Phyllis A. Lyday "Iodine and Iodine Compounds" in Ullmann's Encyclopedia of Industrial Chemistry, Wiley-VCH, Weinheim, 2005. doi:10.1002/14356007.a14_381
  12. ^ "Silver Iodide". TOXNET: Toxicogy Data Network. U.S. National Library of Medicine. Retrieved 9 March 2016.

Cited sources

[edit]